ALL NEW JLT SERIES 2 for 2011-2014 Mustang GT 5.0 and 2012-2013 Boss 302
Have an aftermarket manifold like a Boss or Sniper? Then this is your cold air intake!
MOLDED IN MAF
Its a full 112mm ID at the MAF area
MAF is rotated to the inside or engine side of the tube for a more pleasing smooth look
HEAT SHIELD
Includes roto molded plastic heat shield to block engine heat at idle and low speed.
It incorporates the fresh air inlet from the grill.
It uses a large area to make sure the filter has tons of cool air.
KIT INCLUDES:
JLT Intake Tube with Black Textured finish
4" Silicone Coupler for aftermarket throttle bodies
4-3.5" Silicone reducer for stock throttle bodies
5x7" S&B Powerstack Air Filter
Roto molded Heat Shield
HD Clamps, 2013-14 hood insert plug & all needed hardware
EASY INSTALL
The design and detailed
instructions help make this kit an easy install
GAINS AND TESTING
30-35 RWHP from stock
2-4 RWHP over our original JLT CAI on a stock GT
8-10 RWHP over our original JLT CAI on a BOSS!
10-14 RWHP over our original JLT CAI on a modded GT
We have tested this on three different cars with different stages of
mods and all gained over the original kit. See test videos below
TUNING
A JLT specific tune is required with this kit.
2013-14 owners:, KIT INCLUDES OUR WATER BLOCKER PLUG INSERT FOR NO WORRIES ABOUT WATER GETTING TO THE FILTER.
*This product is NOT CARB (California Air Resource Board) Exempt.
It is not for legal sale or use in the state of CA or any other states
adopting CA emission standards and require a CA Executive Order (EO)
number. Any orders placed for this item with a CA ship to address will
be cancelled.